Rebecca Taylor V1387

Surprisingly, after several years of sewing and forty years of dressing myself, I’ve only just come to the conclusion that deep V-necks are not for me. This top helped me a lot in reaching that understanding.

The long sleeved top on the pattern cover was actually the one that caught my eye. However, since I was a little short on fabric, I decided to give the sleeveless version a go.

I made a few small modifications. I shortened the peplum and left the side seams open. I also omitted the under arm gussets. The pattern instructions are incorrect and (despite being warned) I got caught out and had sewn too far along to insert the gussets without a lot of unpicking. To correct the rather low underarms, I brought the side seams in by about an inch at the waist, narrowing to a smaller seam allowance at the underarm. This worked because the design is pretty forgiving. It is a blouson top with a good amount of ease.

Obviously, the top requires a small snap at the CF chest to secure the centre of the faux wrap and prevent gaping (as per pattern cover). I tried it but didn’t like the look. I also didn’t like the look of a low V on me. It may be different if I layer it with a sheer black top or turtleneck but I haven’t tried that yet. The most obvious solution was to wear the top backwards!

I love the loose cowl of the back when worn backwards. I don’t mind the front either. It works for me because I am small busted and the back gathers provide enough room. Whilst I quite like the look of it exactly as it is (I think the “sloppy” look of the poorly fitted armscye works ok when layered), I am tempted to play around with this pattern in the future, and switch the armscyes around properly for a better fit. I might also toy with the font (back) neckline a little so I can wear the top without a layer beneath.

So I guess the moral of this story is that if you don’t like a top you make, turn it around and try it backwards before you go and fail it!