I had a little bit of wool fabric and lining leftover after the making of Miss Seven’s tailored coat. It was precisely the right amount for ladies skirt. Fancy that.
My original plan was to make a simple, straight skirt using my own skirt sloper. However, when I laid out the wool, it was a lot wider than I remembered and it suddenly seemed a shame to limit myself to a pencil skirt when there was clearly more fabric I could work with.
Starting with a basic pencil shape, I left the back skirt piece unchanged. I then traced the front skirt piece in full, mirroring the pieces as if to avoid cutting on the fold. In the diagram below, the grey shaded pattern is my altered front piece. I extended the waist along the existing pattern line and shortened the hem width a little. I then simply connected these points with a diagonal line.
It was very important to identify and mark the CF point. This was a perfectly fitted skirt pattern and those CF points needed to match up when I wrapped the skirt around.
I cut my lining pieces to the same pattern as the outside fabric, minus about 1.5 inches in hem length. Although, to be honest, I always reduce my seam allowance a smidgen when I sew the lining to make sure it ends up a tiny fraction looser than the outside fabric (you don’t want to end up with any pulls or tension visible on the outside).
I sewed the hems of the lining and fabric together first and then turned the skirt out and basted all the other sides together. I bound the CF edges with the opposite side of the wool fabric, although the contrast is totally unnoticeable. I then attached the contrast (once again unnoticeable) waistband and fastenings.
The skirt I made is a true wrap skirt. It is fastened inside with a ribbon bow and secured with a hook and bar on the outside. I added a leather fastener over the hook and bar for aesthetics. The same pattern pieces could easily be used to create a mock wrap skirt. There would need to be an invisible zipper placed at the side or back. I’d also crop the top portion of the (underlayer) front piece so there is little overlap with the top layer and therefore, reduced bulk at the waistband. This would need to be stitched in place which would limit the freedom of movement that you get with a true wrap skirt, but the benefit would be a sleeker, less bulky front. It’s something I might try next time.